Lou asked ... Mac Allister 35cm electric lawn mower?    |    Ronald Charlwood asked ... Beko fridge/freezer not cold enough?    |    John Broadbent asked ... Advise?    |    suzy asked ... Brother kh-940 not in sync with DAK9 in interactive knitting?    |    Susan asked ... How can I stop my steam iron spraying water with the steam?    |    Click here to ask your question

I have no water flow after replacing head gasket?

having replaced the head gasket on a piaggio nrg power dd gone for a short ride both water pipes are hot but the radiator is cold appears to be rubber smell from engine any advice
dave, July 2010
ok the waterpump is driven by a small belt behind the variator it also runs the oil pump so check this ok as if its broken you need to renew it b4 you ride it.also take the head off and take the thermostat out its screwed inside the head it wont hurt it to be taken out and will eliminate this as a problem.ps the waterpump is right inside the crankcases and cannot be seen easily at all

adam bike doctor, July 2010
also i'd check the water pump hasn't seized. if it has water wont circulate.

james, July 2010
yep dont use it again until you have found the problem. You may well have a air lock in it drain the water and start again.

bb, July 2010
link Click here to see other fixes for Piaggio.