Hi,
I have just removed the gearbox from my mercedes vito 110cdi and replaced the concentric slave cylinder because I couldnt select any gears. Whilst i had it out I checked the clutch and its fine, so I then replaced the gearbox and pressure bled the system, all in all it took me into the early hours of this morning laying on my back on a gravel drive with the gearbox on my chest to remove/replace, not the most ideal way of doing such a job.
Still at 1.30am I finished the job in hand, I started my vito and all was fine again, gears selecting/clutch biting well, all was good, Well until until just a few hours ago when I went to go out and once again I cant select any gears.
Ive tried re-bleeding the system to no effect.
Can anyone HELP!

kev, July 2010

there must be a seperate master cyl for clutch,it only shares reservoir with brake master cylinder.

k, July 2010

Hi,
Thanks for the responses,
Its not the linkages as when i start it in gear with the clutch pedal depressed it is dragging the clutch.
There is a master cylinder but it runs both the clutch and brakes and there isnt any problem with the brakes.
So I ruled out the master cylinder.

kev, July 2010

gear linkages

GHOST, July 2010

is there a clutch master cylinder? might be this.

fred, July 2010