I there, could someone please tell me how I can alter my alarm so that it takes a few minutes longer to go off, this would give me more time to get into the house, cos we have to come in through the garage which is integral to the house. I have a Accenta 6.

Alistair Senior, August 2010

your user code will now be 0123 untill you programme your own code into it,to change code,press 8 zone indicators 1234 will be lit,key in new code,the keypad will bleep,press reset,your own code will now be installed

gts, August 2010

if you dont have the engineering code you will need to do a full reset,this will restore panel to factory conditions,to do this,switch off mains supply to the alarm,remove front cover,remove red lead from battery,remove wires from terminals 13(pa) and 23(set)fit a wire link between these two terminals,and apply power(battery)the system will power up with no alarm condition,remove link wire,replace wires to their terminals,close cover apply mains,the system may now be programmed and recommisioned.hope this helps

gts, August 2010

do you have the engineering code?if it has not been changed by the alarm company,it will be 9999,
to enter the engineer programme,press prog,then enter 9999,the attack indicater shows,
to change exit timer,press one,then enter new time in seconds,i.e.for ten seconds enter 01,for twenty 02,etc for entry timer press 2 and copy the above,when you are finished,press reset,the system will return to day mode with day and power indicator showing

gts, August 2010