I have reset my alarm due to replacing an internal fuse - after a bit of searching for the fault!
Engineers walk test shows that all the sensors are working correctly but whenever I type the exit code the alarm goes off as soon as I close the door.
I have the zone in the hall marked as Entry/ Exit.

Any suggestions - I have the engineers code and book but I cant see where I am going wrong.

Belfast Boy, September 2010

It is OK chaps.

I had set the entry time at 30 seconds but then had done the reset again.

Changed the entry and exit times to suit and all is well.
Happy days!

Belfast Boy, September 2010