hi, i've just bought a ford focus reg54, 1.8 (the old shape)
the only thing i needed to change was the motor for the electric window. (driver's door) if it's not too complex i would like to do it myself. Can you help?
thanks

damien j Briche, September 2010

Hi
The motor and regulator come as one unit to replace 1st remove the door trim screws and handle
2 remove the speaker from the door
3 remove the foam impact bolster if fitted
4 remove the interior handle
5 remove the water shield from the door carefully
6 detach the one touch relay
7 reconnect the power window switch only if motor is still working and lower the glass down untill you see the two 8mm nuts that hold the regulator to the glass you need to slacken off the nuts to release the glass now pull the glass to the top of the frame and using masking tape or simular run the tape from outside of the glass to the inside at least two runs of tape o hold the glass in place.
8 now disconnect the multiplug from the motor
9 remove the 5 screws that hold the regulator in place
then remove the assembly out through the lower section "biggest Hole"
to refit work backwards....

Have fun and do try it yourself
PG

Phil, October 2010