can anyone help pls, iv jst fitted a clutch slave cylinder on my astra, built it back up and someone fitted the selector on the top of the box for me but has now left the country, drove ok until it jst slipped out and all i get is a wering noice, took it off and put it back on few times, and still wont select into gear, dnt no wat im doing wrong, any ideas woud be greatly appreciated, cheers sam

stokey sam, September 2010

remove gearstick gaiter and align hole at bottom of gearstick on the left hand side with holein lower hosing with small screwdriver having already slackened off pinch bolt on selector rod outside at gearbox then remove plastic plug on gearbox selector mechanism and move the shaft on it until u can locate a locking pin or similair into it then tighten your pinch bolt and remove both locking pins

danny, September 2010

think the adjustment is from underneath,you will see the torx 50 pinchbolt,usually make sure the g/box is in neutral,get someone to hold gearlever in neutral half way between 5th and 1st and shouldnt be too far away,may need the odd tweak

wickham, September 2010