I have recently installed a melcom ST6100 alram control panel, however whe I attach the alarm box the tamper light remains on so will not let me set. There is no tamper fault as the lights on the alarm box signal correctly, if I press the panic alarm it all works ok. But because the tamper alarm is always on I can't do anything, any ideas?

First time alarm installer, October 2010

how do you reset panel

roger, August 2019

whats the tamper switch?

first time alarm installer, December 2010

you have ans your own question,check the tamper switch and or the wiring from the bell box

gts, October 2010