impellor stripped on circ pump will also cause no drain.to test this hold the drain hose over a bucket and keep dropping the drain hose down until water comes out.if water comes out at a low drain hose hight then stripped impellor might be the issue
ck, November 2010
Try it on a different cycle and see if it drains away.
It might be the pump (suggest a rinse and hold cycle that normally does not involve heating) - like this you check the pump out.
OR
If it does not dran away it might be a printed circuit board fault eg water is not reaching temperature and cycle will not continue till water temperature is achieved. This might also suggest faulty heating element.
