Ive got a Leisure Rangemaster 100 clock stuck on auto and my gas oven dont work.
I have dissconected the two blue wires and to dis arm the clock. trying to by pass the clock. but still cant the oven to light. any ideas.

Kind Regards

Pat doyle

Pat Dotle, November 2010

Sorry, hole not whole.

Jem Dunford, January 2016

Cocktail stick solution worked for me. Cleaned out whole put button back in, hey presto.

Jem Dunford, January 2016

I've just had a similar problem with my Leisure Profile Plus...the electronic timer thingie mysteriously changed to and stuck itself on Auto (I've never cooked on Auto) and none of the little buttons would work, so although the rest of the cooker will work...the oven won't. I think my cooker is too old to get a replacement electronic timer, so that coupled with the fact that they also don't make cookers now with the same width, my problem was looking seriously expensive to resolve in that not only would I need a new cooker but I might have to possibly change the kitchen to fit around it!

However...I discovered the little buttons on the timer come out completely. So I used a cocktail stick to poke about inside the holes where the buttons go till the Auto mode light disappeared and the cooker went back to manual. And my oven works again as before. So fingers crossed.

So a cocktail stick has saved me having to spend a load of money. Give it a try.

dianeirttm1991, December 2010

I have the same fault and need to examine clock. in the mean time I switch off power to the cooker for 60 seconds, select manual, turn on the power supply, turn the clock adjust button untill it reads over 12 hours, and I can use the oven. I have a tricity bendix sie 505 gr. hope this helps.

cimerron, November 2010

I have the same fault and need to examine clock. in the mean time I switch off power to the cooker for 60 seconds, select manual, turn on the power supply, turn the clock adjust button untill it reads over 12 hours, and I can use the oven. I have a tricity bendix sie 505 gr. hope this helps.

cimerron, November 2010

There's usually a reset process - power off and on to make the clock flash - depress and hold buttons 2 & 3 from the left - set the time (any time will do) using the plus and minus buttons. The oven will then work - unless the clock is defective.

Peccavi, November 2010