I have a Scantronic 9800 alarm and am getting a T6 error code and service and fault lights are both on. I tried entering the Service engineer code which is "0 enter 7890 and then 99 and get an internal bell noise.
How do I switch the service light and fault light?
Dario, December 2010
no,it wont
gts, December 2010
Will allow me to do this even though the service and fault light is on?
Dario, December 2010
you forgot 7 and 8 :-)
gts, December 2010
How about getting pen & paper, marked 1,2,3,4,5 & 6.
Put the system into WALK TEST & work it out from there
acorn, December 2010
checked my manual and have found the page with the zones, but it is blank as the engineer that fitted it didn't fill in the zones.
Is there anyway you find out by putting codes into the alarm keypad to find out where the zones are?
Dario, December 2010
i,ll try once again dario,when i ask whats on zone 6,the answer is NOT how are zones normaly set up,get it?comprende,capire,verstehen,verstaan?????
gts, December 2010
am losing the will to live acorn,call the nurse!!!!
gts, December 2010
Can I say something please?
Does this remind you of pulling teeth?
acorn, December 2010
Carry on your doing well GT
Alarm, December 2010
do you not have your user manual?it should have the zones near back page,have you removed any covers of any pirs?or had any work done to house?
gts, December 2010
I not sure how my zones have been set up. I have 3 PIR sensor downstair, 1 in the dining room, living room and kitchen and 1 up stairs. I also have 3 sensor on the front and rear dear door and patio door.
