Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Click here to ask your question

How do I fix my Easy Lam II?

My heating element is not reaching 300-350 degrees but staying right around 250. I have tried adjusting with the temp knob on left but does not affect the temp at this point. Please help.
Kari, January 2011
I need to repalce the front, top roller on an easy Lam II anybody know the best way?

Teacher in need, November 2011
I fix laminators for a living the nice tech folks at banner will be glad to help you 800 572 2144

You thermostat s going bad it has the knob on the end. Do note which way to turn to increase temperature:) Most laminators are backwards from your typical home thermostat, this cause wierd issues, people thinking they are turning temp up when really they are setting it cooler:( If you remove the knob in the middle of the shaft theres a small hole with a screw in the bottom, it calibrates the thermostat, turn it to increase temp. If the machines old I would replace the thermostat its easily replaceable and not expensive. If you call banner and talk to robert tell him bob from pittsburgh said hi

bob haller service and sales pittsburgh pa, March 2011
Hi fix these machines for a living. The thermostat is likely going bad. theres a calibration screw in the middle of the shaft the temp knob is on. if your anywhere around pittsburgh i give free on site estimates. or you can call banner america
1 800 572 2144 ask for robert tell him bob haller said hi

bob haller service and sales pittsburgh pa, January 2011