my remote key fob for nissan almera tino has just stopped working have changed battery but no differrence have to use key in drivers door to open doors now any tips on how to fix, thanks

jimmy, February 2011

Hi.
This is the only way to to it.
If this does not work then you have a problem elsewhere.
NOTE: A maximum of 4 remote controls can be programmed.
Obtain all remote controls.
Switch ignition ON and OFF 6 times within 10 seconds.
NOTE: DO NOT remove key from ignition switch.
After 2 seconds indicators will flash twice.
Programming mode activated for 2 minutes, proceed as follows:
Press and hold unlock button.
Press lock button 3 times.
Release unlock button.
Indicators will flash once to confirm correct programming.
Repeat above procedure to program remaining remote controls.
If 4 remote controls have been programmed:
After programming last remote control indicators flash 3 times.
Programming mode deactivated.
If less than 4 remote controls have been programmed:
Switch ignition ON, indicators will flash twice.
Programming mode deactivated.
Check operation of all programmed remote controls.
Good luck.

Rob, October 2013

thanks kev does anyone know how to reset remote key fob for almera tino.

jimmy, February 2011

It might just want resetting,ask on this site.
This worked on my motor.
Also the inside of the fob may have broken up.

Good luck.......

Kev, February 2011