You can set everything on pedestal and when you hit start, nothing happens. Removed pedestal everything is connected, motor brushes look great with 5/16" still protruding from holders. Cleaned all the dust off of circuit board. I`m to the point where I think there is a Transister, SCR or Capacitor in motor circuit that is bad and maybe involved with the IC`s.

musicman 4, February 2011

Remove control panel in front of you and unplug all wires and reinstall them one at a time. Also do the same where pwr board is as sometimes electrolysis forms on pins and etc. Make sure all plugs are connected.

Jay, February 2011