home Fix label Security Systems label_important Home Alarm Systems category Scantronic

Scantronic 9651 Global Tamper Front Door - call Engineer on Display?

Hi,

Moved into our house a year ago, we have Scantronic 9651.
Just Changed my front door, as the fitter removed the the old frame the Alarm went off which I then stopped, now the disply shows "Global Tamper Front Door Call Engineer".
I've read through the Hardwired Control Panel guides for both Installation and User Guide and can not work out what to do?

Can Anybody please advise??

Many Thanks

Jay, February 2011

home Fix label Security Systems label_important Home Alarm Systems category Scantronicdone

hi guys i have problem with my scantronic 9651 it keep saying global tamper???(( any help please

amo, August 2012

glad we got you sorted out,be well,

gts, February 2011

no picture yet

gts, February 2011

ok,i dont norm give my number,but here it is 07763229681

gts, February 2011

how are you getting on?have you got the un message yet?.

gts, February 2011

Can I call you on this?
This is all very new to me.

Jay, February 2011

looks like the front and back doors are on zone one so when you omit these you will be ok,but then we need to deal with the global tamper,

gts, February 2011

you may have to press the tick 2 or 3 times

gts, February 2011

I hope they are, the previous owner did not leave any proper info apart from the following

Zone A = front door,lounge,back door,kitchen,down hall, up
Zone B = front door,back door,lounge,kitchen down hall
Zone C = front door,back door,lounge
Zone D = front door,back door,hall up,lounge,kitchen

if any of that is useful??

Jay, February 2011

ok,go to the panel,key in 01,press the tick then press o till the panel reads un,then come back

gts, February 2011

if both doors are on zone 1,then thats ok,

gts, February 2011

Can I remove The Zone please, would there be a zone for the back door aswell as too had a door contact?

Jay, February 2011

good,now you can either fix the cable and door contact,or remove the zone one from the system,what would you like to do?

gts, February 2011

Hi gts,

i've entered the 0 then 7890 and it has gone into installer mode,

I've had both my front and back doors changed would that mean removing both front and back?

Jay, February 2011

yes you can,but alas you need the engineering code .the factory code is 07890,try keying that in,if it shows installer mode,then your ok,try it and get back to me,
if you get the installer mode up,do not touch any button untill you come back here

gts, February 2011

Unfortnatley, the previous owner had wired that doors contacts badly from the top so when the olf frame came it took out allot of the wire which was then cut by the fitter.
The installation guide does give a Engineers Defualt Code.
I'm not sure how to use it or what to do?
Can I remove the Door contact setting and just use the PIR's??

Thanks

Jay, February 2011

if you have the engineering manual,then you will have the engineer code,if its not been changed by the installer

gts, February 2011

the wire on the door contact has been cut,repair it and replace the door contact,once you have done that,try keying in your code to reset,if it wont,then its the engineering code you will need.joiners do this all the time,
you would think they would know better,

gts, February 2011

link Click here to see other fixes for Scantronic 9651.