it is simple to carry this out, take the driver side kick panel out, there are to bracets holding the pipes in tight, undo them and remove, there are 2 clamps around the pipe to rad, take the bolts out completly and leave the clamps hanging round pipe. pull these 2 pipes free from rad. there is 2 bolts either side of the plastic surround which you may need to remove to free the rad, hey presto slide it out and reverse the order when putting back and remember to be shore you fit the rubber washers back with the pipes and make sure they meet up together otherwise you will not close the gap with the clamp properly..good luck....
Tony, February 2011
