Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

veritas 8 zone 2 not responding?

one of my detector's on my alarm does not activate it. there is power and the light flashes on the detector when you enter the room but alarm does not sound when set.. i done a walk test and all zones are functioning ok apart from zone 2.(the zone in question) its not even registering on the keypad. any ideas.
the keypad is a veritas 8.
karl, February 2011
Must be stoopid week, and its only Monday.

Back to basic`s, check and test.

Alarm, February 2011
am i missing something?alarm guy,this is a no brainer,start at the panel,fech it,i give up,!

gts, February 2011
Depends how its been programmed.
~No way of telling intil you try.

Alarm, February 2011
thanx. is this something i could do by turning off the the tamper setting or do i need an engineer.

karl, February 2011
Test the cable, then the pir.
Or swap with a known working one.

Alarm, February 2011
link Click here to see other fixes for Veritas 8.