Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Hotpoint WT960 Door Seal Advice please - URGENT!?

Need to replace door seal on WT960 - is there a spring / clip on the front of the seal that attaches to the main case front or is it just press in?
How does the kick plate come off to allow access to the lower front panel screws?
Thanks!!
Robert, February 2011
and it dont matter where you put it back on,tho the bottom is easier to get at

mm,, February 2011
its norm at the bottom of the tsg,(tub shell gasket)door seal,just pull it off the wire will come off with it,very simple

mm,, February 2011
Many thanks for your help - I don't see a spring which is why I raised this question - is it at top, middle, side?? Or is the wirw itself a spring? Sorry for being dozy - under pressure to fix!

Robert, February 2011
there is a wire that is tensioned with a spring,just pull the tsg off gently,
the kick plate norm just pulls off,you also need to remove the bezel to gain access to the 3 top fixing screws,its not a hard job,just fiddly if you have not done it before,remove the plug top from wall socket before working on the machine.you need to take the worktop off too,3 screws,

mm,, February 2011
link Click here to see other fixes for Hotpoint WT960.