andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

Moving an ADT motion sensor?

I have an ADT system and a motion sensor that was installd in the basement when we built the house. I am having the basement finished, and need to "remove" the motion sensor so we can drywall. I want to just take it off (and disconnect it) and then put it right back up in the same place (reconnected). They want to charge 115 for the first 30 minutes of work - and that would be x2 to have it taken down and then put back up - which I think is crap. Can anyone tell me how to take this down and put it back up...
Scott, February 2011
what you have to remember,you need us professionals,we dont need you,

gts, February 2011
it would be nice if one of you sods replied,manners cost nothing

gts, February 2011
if i where you,i would carefully pull it off the wall,do not open open it,then just use silicon to stick it back on after your done your job,:-)

gts, February 2011
alas.they will have an engineering code to reset the panel,as soon as you remove the cover of the pir,you wont be able to use or reset it,they got you over a barrel mate,

gts, February 2011
link Click here to see other fixes for ADT.