The 3 bolts at the back of the drum have worn away the holes and it's making a really loud banging and clanking noise when it's turning. I wondered if it was worth buying a new drum off the internet and trying to replace it myself if it's not too difficult. I've had the drum replaced before for this exact same problem a few years ago and it was expensive to get someone out to replace it. Any help appreciated, thanks.

Belle, February 2011

what a waste of money,its a budget make,buy a good dryer,better in long run

mm, February 2011

basically remove ALL the screws in the back panel and disconnect the wiring so you can remove the whole back panel.make a note of wiring or photograph it before disconnecting to help you know where they go on reassembly

ck, February 2011