how do i change the centre bearing on my ldv convoy how do i split the propshaft

trev110, February 2011

ensure you mark front part of shaft in relation to rear part,[before removing[, i dont think the master spline is very obvious but will cause problems if not lined up!!!

k, February 2011

remove 4 bolts at g/box,2- 9/16 bolts on centre bearing,drop down and slide off splines to separate front from rear,at c/brg there is a 11/16 bolt with locking tab holding yoke on to shaft,remove this to gain access to bearing removal,if you dont have a press a 2lb hammer and chisel can remove the bearing,remember which way it comes off and refit in reverse,good luck

cdc, February 2011