Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Click here to ask your question

Aqua 3000 shower fitted new 3 months doesnt provide water at required temp?

In mid power setting with 10 temp dial setting (max) we can get warm water, on high setting with temp dial between 6 and 10 we get scalding water, any lower than 6 and the power light cuts out and the water runs cold

Ideally we require the water to run hot with a high power setting

Is this possible?
scott wedderburn, March 2011