When the washer finishes its wash cycle, it drains the Washer. Then just before it starts or tries to start its rinse cycle, we also get the ERROR CODE F03 and you cant even turn the washer of using the on off switch. We have to unplug it from the mains.
We also have just had an engineer out who has looked at this forum, and acted on some of the usefull information on it.
We then put the washer on its wash cycle once again and eagerly awaiyed the results. Oh no we once again get the ERROR MESSAGE F03 at the end of the wash cycle.
He says he will investigate further, in the mean time though we are up the creek without a paddle...can someone please shed some light on this for us???.
Ian & Denise.

Ian Kendall, September 2006

Just as the machine finishes its 60 minute/60 degree programme, water comes pouring out of the soap dispenser.

Any suggestions?

Andy, February 2010

do the main electric motor have brushes

kevin, August 2008

WHAT IS FAULT CODE 7 ON WF860P THE MACHINE WASHES BUT WILL NOT CONTINUE THE PROGRAMME BUT WILL RINSE AND SPIN IF SELECTED AS A SEPERATE PROGRAMME

Rod, October 2006

hello its Barn again i"ve looked into your fault code and the tech manual is saying its a ntc or module fault. so ntc is the device which registers the temprature. and the module is the main control board which could have a faulty component on it hope this helps

Barn, September 2006

www.hotpointservice.co.uk
try this site

Barn, September 2006