i got a rather damaged midimoto for next to nothing but the complete wiring loom is dead. the engine funns fine but no wiring at all for the kill switch ...where do i make a connection to the engine and how ...the kill switch i have has 2 wires to it ...can anyone help. sorry dont know make or model

daz, September 2006

in simple Term From the Spark Plug Removable end(cover), To A Lock Off Switch (flick On Switch)To the Bike's Engine body Or Frame..

So when current passes throw the sparkplug head It Uses The FasterWay Of hitting Ground (Frame) But this time it will be Going thow the switch When the circuit Is Compleate..No Spark & No Source Of it Lighting In the engine Very Simple

Try this, January 2008

Hi, find the SUPPLY WIRE (not the thick one going to the spark plug) going to the H.T coil (it supplies or makes the high voltage power to the spark plug) connect one side of the kill switch to that wire (its usually a black & white wire on most bikes) then connect the other wire of the kill switch to the frame of the bike. what happens is when you then push the kill switch it bypasses the coil and cuts the power to it (electricity will always try find the shortest route to earth) If that doesnt work then check what kind of kill switch you have..normally electricity will only pass through it when its pressed.....if other way around then put the kill switch in series with the HT coil supply wiring.(wire originally connected to HT coil now into kill switch out other side of kill switch and into coil) Good luck....

Rowland, September 2006