How do I change the big belt on my Creda Reversair Sensadry? I need to know which panel/panels I need to remove in order to do the job. Any guidance you give would be greatly appreciated.

Ruel, September 2006

Perfect answer. Managed to replace the belt on mine too. Princely sum of £10 these days! Part code is 1870 H7.

John B, January 2020

Fantastic, thanks Roy.
Was debating buying a new dryer then google'd your answer.
Ordered the part off ebay at £3.00 + postage and it arrived 2 days later.
Changed it as per your instructions today and it is up and running perfect. Thanks so much you have saved me a fortune!!!
Thanks again
Oliver

Oliver Stephen (Scotland), January 2009

Thank you Roy. Job is now completed successfully.
Thanks again for your help.

Ruel, September 2006

Turn upside down. From front, remove the thin piece of housing below door.
Take out the front 3 screws either side of dryer base. slacken off the fourth ones but don't remove them. Likewise, don't remove the screws that attach the base to the back.
Now you can see and have room to get into the motor and pulleys.
The front of the dryer will pull away just enough for you feed the belt over the drum.
Slacken off (being careful not to remove them) the 3 screws that hold the motor to the base. Then pull the belt in between the 2 pulleys onto the motor.
Tighten the 3 motor screws to take up the slack.
Tighten and replace all screws. Job done

Roy Claxton (Scotland), September 2006