My Proform 730CS treadmill trips the internal fuse if i go any faster than about 6.5 mph after a few minutes. I have resorted to taking off the cover and blowing a fan on the circuit boards and motor but this is only fixing the symptom not the problem.

Tom, September 2006

Where is the breaker switch located on a sportcraft treadmill tx400

julie, September 2009

it might need new control board.
Remove front cover and look at control board, and power supply board to see if their is anything burned.
Thank you

Samer, August 2009

The track on my Proform 730cs is slipping. I have tried adjusting it but it did not work. Any suggestions?

Marty, July 2008

Mine is ten years old and start quitting on me during runs. Talk about ruining a good run! It would start working after a few minutes but still very frustrating. I ordered a new circuit breaker/reset switch, which is the same button I was pushing to reset the treadmill after it stopped. I ordered the part online from the Treadmill doctor at http://www.proformtreadmillparts.com/. The part was like $15 plus shipping. Easy to install, just removed a few screws underneath the treadmill slide off the 2 wires, snap out the old part and install the new circuit breaker. It’s been 3 weeks and about 12 runs and the problem seams to be corrected. I was thrilled; I was ready to buy a new treadmill. Now I can save my cash, cha-ching. Good Luck.

Patrick, January 2007