Lou asked ... Mac Allister 35cm electric lawn mower?    |    Ronald Charlwood asked ... Beko fridge/freezer not cold enough?    |    John Broadbent asked ... Advise?    |    suzy asked ... Brother kh-940 not in sync with DAK9 in interactive knitting?    |    Susan asked ... How can I stop my steam iron spraying water with the steam?    |    Click here to ask your question

hotpoint wd440 error code f01 4th light down flashing?

where is the motor triac please,and can it be tested and replaced.
4th light down i think is the time saver.
and the on-off flashes as well.
mant thanx
simon, September 2011
hi,found a wire had come adrift on the motor plug as soon as i took motor off.it had frayed,burnt then come off.
i couldnt remove the spade from the plastic holder,so bent it out with pliers,resoldered it and forced it back in.
all works fine now.
only bought the m/c to strip for spares,so a good outcome.

simon, September 2011
Motor triac is part of the main module. Make sure your motor is ok - ie check the carbon brushes BEFORE fitting a new module. We stock the module at £65.88 including postage. The module is programmed up and ready to fit ! This would be an exchange transaction - we send you the module - you fit it - then send your old unit back to us. If the new unit doesn't sort the problem then you can return it for a refund, less our handling charge of £9+vat. To order, call us on 0115 9652118 or order online at www.emwelec.co.uk Tony EMW Electronics

www.emwelec.co.uk, September 2011
link Click here to see other fixes for Hotpoint WD440.