I want to exchange my exit/entry point.I currently use the rear door of my home for access and this is where my alarm panel is positioned.This is exit/entry zone 1.I want to use my front door for access (zone 4) and would need a minimum 20 second time slot to reach panel to enter code.Is it possible to change over these access points? Please can anyone help advise me with this?I would very much appreciate any guidance with my question,thank you.

Terry Griffiths, September 2011

and no need to say thank you mr griffiths,we are used to ignorant people on this site who ask our advice and dont have the manners to reply or say thank you.

gts, September 2011

we dont use these panels,they are budget range,but you can download the engin manual from net,just key in the make and model number,and there you go ,!

gts, September 2011

hope that of use to you

gts, September 2011

easy way to do it is to open the panel,swap zone one for zone 4 that is remove the wires from zone one fit them on zone 4 and vice versa,but,you need to make sure there is not a beam between you and the keypad
to change time,press prog,all leds flashing,then key in 9999.press 1,zones 123 leds should be lit,input a new exit time,eg,for 20 seconds input 020 this is the exit time,for entry time press 2 then leds 123 should be lit,key in 020 -20 seconds,to exit engin prog press reset twice or if you can get the engin maual you can reprog the zones without disscon the wires

gts, September 2011