I am finding that the temperature dial on my Creda Jet Spa make no difference to the water temperature.

My water pressure is fine so i don't believe that is the issue, which just leaves the possibility that the heater unit has been wired incorrectly.

There are 4 connector points on the unit, but i have not been able to find any details about correct wiring, can anyone tell me which points the wires should be connected to as i am unable to locate any wiring schematics online.

Thanks.

Paul, September 2011

Hi , I have this problem with my brand new just fitted Jetspa. It looks very much to me as if the two bottom gears are not meshing with the third TOP gear that controls the stabiliser control valve. I'm awaiting a creda repairer to sort it out.Hope this helps

Big JM, September 2011