I have a homelite 240... 10629... and I need to adjust the carb. can you help me? There is a (high) and (low) above and below each other next to the idle (screw). How many turns clockwise or counter do I turn them from fully closed??? On the left side it says "homelite 240". The exhaust is on the right. Spark plug on the right on the back, next to the handle. I have a 15" 1/2" bar from the chasis teeth next to the blade. please help, if you are able...

professor 189, September 2006

All you need to do is turn both the high and low screws completely in, then undo each screw 1 1/4 turns. Your chain saw should now start, you may need to hold your chainsaw with the throttle on, turn the high screw either in or out slightly to get full throttle. Tick over can be adjusted on your tick over screw. Hope this helps. Regards, Rich

Rich, September 2006