looks like you know what you are talking about. i have a fisher & paykel washer model-wa37t26g [gwl15/iwl16] it stop working after a large blaket was finished spinning. put in a new load of clothes &it was dead, no lights or bussers,unplugged it for a min. or two, just dead.the clear tubing with a blue wire in it,was unplugged. would this blue wire be a kill switch when it is unplugged?

cv valdosta, November 2011

Hi & thanks for the compliment. I am not familiar with that model but if there is no lights/power etc then either the control board has died for some reason or maybe the drain pump which also supplies power to the display. Check wiring is fully plugged in to the drain pump underneath the bowl. Tip machine back against the wall and look under. The plug may of come part way out if it was unbalanced. The clear plastic tube is the air pressure tube for the water level. The blue insert is not a wire so will not stop the machine. It should be plugged in to the control board and the other end plugs on to the side of the outer bowl. Without a test meter you can't check much else yourself. Post back here with your findings.

Lincoln Appliance NZ, November 2011