Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Click here to ask your question

tumble dryer?

tumble dryer not heating change heating element still not heating .indesitg74c
jason perrine, December 2011
expensive mistake jason.,iam assuming you haven't been able to test the components with a multimeter.most heating assemblies come with T/stats fitted,however your T/stat x2 are fitted to the heater housing on the dryer.take a look at one of the T/stats for a red dot on it,it may have a small hole on the rear where you can reset using a pin.if not you can buy a T/stat kit for around £15.00 .these are the first thing you should of checked or replaced first.iam assuming you have done the usual checks first before you suspected the heater circuit,=ensure the condenser is spotless and remove all fluff/gunge from the condenser housing.=ensure the condenser pump and pipe is not blocked,.if the filter light is illuminating the heater circuit is disabled.if you still have no heat after you have replaced the T/stats then the problem could be the heater relay on the pcb.anyway good luck with it .

ozone, December 2011
you can try changing the thermostats,some model also got a safety thermostat between front cover and heater plate

johan, December 2011