Leith asked ... Bosch Classix Type WKM41 front loader washing machine?    |    Pam asked ... Do I need to open the housing to dry the motor?    |    James asked ... Remove enterprise enrolment from an Asus Chromebook C523N?    |    tom schwartz asked ... Bosch maxx 6?    |    Noman asked ... Reverse light switch?    |    Click here to ask your question

307 1.6 petrol 2002 limp mode after battery change!?

My 307 has a fault saying Anti pollution fault and engine management light is on. car starts ok, but has no power, it wont rev past 1500 revs. All i did was replace flat battery. Can I reset this fault?
david, December 2011
See

http://www.benzworld.org/forums/w202-c36-amg-c43-amg/1452724-limp-home-mode-after-battery-replacement.html

I know yours isn't a Merc but it has got to be worth a try?

ChicksFan, December 2011
You could try this.
Get in the car, turn the ignition on. Leave it on for 10 seconds. Turn the ignition off, leave it for 10 seconds and then remove the key.
That may reset it.

Good luck.

ChicksFan, December 2011
The engine computer will of registered the low battery voltage and put it into protection mode, you will have to get the codes read with a diagnostic reader and reset, £20 from an independant garage.

nigel, December 2011
Did you replace it with a brand new fully charged battery?

ChicksFan, December 2011
link Click here to see other fixes for 307.