I had a major power cut on Christmas Eve which has knocked out my alarm keypad.All three PIR's are still working, the lights on the bell box and the power light on the control box in the airing cupboard. However there are no lights on the keypad and the door sensor is not working.my alarm is an accenta 6, any ideas ?

bducky, December 2011

I've just had a similar problem on an accenta G3 panel. The red light was "on" on the panel, but the RKP's were dead. I checked all the fuses and they were fine, but when I put a multimeter on the transformer output on the pcb, it registered less than 1 volt, so buggered transformer. Get you multimerer out, and start checking the outputs. And if someone out there knows where I can get a replacement transformer, I'd appreciate a response.

Mike T, December 2011

Oh come on, you managed to find your way here, why can't you find the answer to your problem, after all it's the same answer that is given to 95% if not more of the questions here?

Battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery, battery.

Oh, and don't forget the battery.

acorn, December 2011