home Fix label Kitchen Appliances label_important Dishwashers category Hotpoint

hotpoint aquarius dishwasher DWF30 will not fill?

The dishwasher will not fill at the start of the cycle. The inlet solenoid has been bench tested is working but the machine is not calling for it to operate - It is if the machine thinks the water level is Ok or the machine is calling for the colenoid but no power is getting there.

Bob, October 2006

home Fix label Kitchen Appliances label_important Dishwashers category Hotpointdone

Hi Bob

Model DWF30
I need to reseat Detergent compartment locking mechanism,
please help.

Many thanks
Sharma

Sharma, November 2015

I have a problem with the same model. It seems that the water is suddenly not getting into the machine. It just won't fill or start the cycle now.

KevDublin, March 2008

it's probably a control board fault, i have the same problem but my pump runs also and the board is £123 so i think i will not bother and get a new one am not happy with hotpoint spares costs and as i have had loads of problems with all aquarius appliances (washing m/cs) will probably go for different brands.

jason jones, March 2008

Had a similar problem with a dwf30, turned out to be a bad solder joint on the circuit board behind the facia control panel. One joint on one of the relays was visibly bad, resoldered them all and it worked.
If the float switches are ok, check the circuit board.

ronny, December 2007

Hi Bob
Did you ever get you diswasher problem sorted. I have the same model and it has the same fault.
any ideas?
thanks
mark
rmdk@btinternet.com

Mark King, September 2007

link Click here to see other fixes for Hotpoint.