I recently fixed a loose drum but in doing so I accidentally pulled off some wires. It now doesnt heat in the main cycle but gets hot in the cool down cycle. I have (on the tag block) left to right:

1) Incoming live (brown) connected to White with Brown stripe wire and a red one (which goes to the High/Low switch on the front)
2) Incoming neutral (blue) connected to light blue which goes to the over temperature sensor.
3) spare
4) Black with White stripe connected to Black (which goes to the High/Low switch on the front)

On the heating element looking from the top, from left to right;
1) Grey into a heat resistant sleeve
2) Grey into a heat resistant sleeve
3 and 4) Light blue to over temperature sensor

Is this correct?

Steve, December 2004

need the diagram too please johnneelyhotmail.co.uk thanks in advance

john, February 2012

if you put your e-mail on i will send the diagram

mick, April 2005

I've just taken my White Knight SensorDry apart (CL447WV), as the heating element has gone, and the wiring was as follows:

1) Incoming live (brown) connected to White with Brown stripe wire
2) Incoming neutral (blue) connected to 2 blues, one of which goes to the over temperature sensor.
3) spare
4) Black with White stripe connected to Grey into a heat resistant sleeve
On the heating element looking from the top, from left to right;
1) Black (which goes to the High/Low switch on the front)
and Grey into a heat resistant sleeve
2) Red (which goes to the High/Low switch on the front)
3 and 4) Light blue to over temperature sensor

HTH, Gary

Gary, January 2005

Hi have you been able to find out an answer as we have the same problem. tipster1@btinternet.com

Tania-Maria, January 2005