Machine washes OK but will not move on to the rinse & then spin cycles . It will work if we turn the dail to rinse, wait till its finished the turn again to spin posistion. What is the most proberbal cause of this fault

Neil Davies, April 2012

Check filter bottom right front for blockage ($2 coin will cause blockage and fault u describe, also check brushes on motor (should be 8mm+ long [carbon rectangle inside spring]=if too short , can't make enough power to spin. Replace brushes (very common fault which also gives your symptoms) Also check for lose connectors, as if not earthing properly, won't spin. If none of that works, ring repairman or buy a Miele. Good luck

Justin, May 2012

Machine has double cold inlet valve possible one valve coil open circuit check with continuity meter. If so it will get to rinse position and stop waiting for water to fill. When you select separate rinse it may use the good valve for that prog.

Kenjo, April 2012

is it draining water out after wash

Ck, April 2012

timer selector,not sure on your model but on some timer you can get the small timer control seperetely from complete timer unit

jj, April 2012