Scantranic 500R. I believe I have secured the movement dectors inside the sensor so can't understand why the main alarm won't let me reset and keeps flashing 'tamper' for this particular sensor. How do I relearn the device to the alarm?

kch, May 2012

Had to add a 500R to a M1000 as the house designers had flooked up as per and had a "Common" door on Wards. Not the best idea but we had two contacts running one door. One hard wired one radio. It worked but due to the construction and the location of the panel we had a few issues mentioned and the panel was 15 ft from the contact.. But foil backed PB and steels made it a nightmare. So a battery change was done every service (6 months) and a relearn was needed for that device, yet the shocks ( another overlook after a design review by the arciprat) were fine with a battery change.
Cooper said there was anissue and replaced the panel once, but we still swap out batts every 6 months and relearn.

Alarm, May 2012

Thanks xx

Told you there was a glitch.

Alarm, May 2012

we seldome get a thanks

gts, May 2012

and is ok,no need to thank me :-)

gts, May 2012

and that is why i said its the back tamper :-)

gts, May 2012

i had to do the same thing kch,i found that thecase distorted when you screwed the back to the wall ,so i had to pad the tamper up as you did,

gts, May 2012

A relearn was definitely worth mentioning Alarm,
I had a similar issue,.

Both tampers were fully closed,that I was certain of, because they metered out ok,.
An alarm condition would occur each time after the pir`s sleep time out period ,so I knew it wasn't a communication error.

A relearn did the trick.

A glitch maybe ?.

e manno, May 2012

Thank you I had to 'pad up' the back to secure the back pressure pad. It has worked - so far :-)

kch, May 2012

I seem to recall an issue wirh the 500r at one stage and b4 it was sorted a relearn helped.

Alarm, May 2012

you dont need to relearn the device,unless you have removed it from the system

gts, May 2012

re-check the back tamper,this is where you prob is

gts, May 2012