Hello, i was wondering why my tamper light flashes,originally my thoughts were the battery, which i have now replaced.I can use it still but the tamper trouble worries me. I know it's an old alarm but could it be failing electronically. Should I replace it with something similar or newer?.please help me sort it out as we are concerned.

Jake, July 2012

replace it with some thing better,much better it wont be too hard,

gts, July 2012

Have yo checked, have you got into engineering??

e manno, July 2012

From day mode enter your eng code, if correct eng code entered then all 8 zone LEDs should flash, press button 8 to enter the timer menu.

At this stage if LEDs 1 or 3 are lit, or both then press 2 to disable the timer,.

If you go in and all appears ok then it's a new panel I'am afraid to say, don't waste your money getting an engineer in,buy a new system.It probably has a bad joint somewhere on the board.

e manno, July 2012

Can you tell me how, we have the user booklet although rather tatty I have to say, but no mention of this in there.Not sure if some pages are missing, thnx for your time.

Jake, July 2012

If the system is operational at this stage then maybe something to do with the service timer, have you been into engineering and checked this?.

e manno, July 2012