i have istalled a 9448es with one keypad 9427... i did some mistakes in wiring and the two batteries whas below10V but i ve programed the9448 and evrithing whas ok exept that 3 zones shows alarm red flashing leds...the next day when i rewired the 9448 i dont have the red flashing led(zones, power, etc) on the 9427...when i push the buttons they make a sound but they do nothing

stami, August 2012

what two what two batteries are you talking about ?this panel is very easy to fit and programme as has been said,get some one who knows what they are doing mate, ,

gts, August 2012

I don't want to appear rude here, but you clearly don't know what you are doing.Your first steps regarding installation should of involved reading the book, familiarising with all wiring and connections.

I would also say to any novice " set the system up on a work bench, and test before you commit to the install",problems relating to the wiring can easily be addressed and sorted.

This procedure will also help you to understand how the circuits work, especially the tamper circuits,PIR and other detecting device wiring.Alarm has diagnosed your issue, regarding your incorrect connection of your remote keypad, resulting in one or more blown fuses.

Three open zones ,on what sounds like your Initial power up doesn't bode well for your wiring skills.Start over or get someone in who knows what they are doing before you ruin a perfectly good panel.

Be safe and good luck :)

e manno, August 2012

Rip it apart (you have done as much anyway) read the book start again. Checking all fuses with a meter not eyeballs.

Alarm, August 2012

AS other.

Is the keypad remote, if so disconnect. just wire main unit. DO YOU have mains to main unit? IF not why not?
GO back to basics. READ the installation information.
THEN come back here.

SD, August 2012

Dear god, the weekend approaches .

Ask a silly Q get a silly A, August 2012