I posted this under another question before, but I now see that's not how this site works, so I thought I'd better start a new question...

My 97 Saxo's washer pump makes a whirring noise but nothing comes out of the rubber tube, if I disconnect it from the pipe on the underside of the bonnet that feeds the jets.

So, the nozzles may or may not still be blocked, but that's not the main problem.

The rear window washer stopped working the same week I bought it. The front washers were working but not very well. They had to be bodged by the garage to get through the last MOT.

When I fill the washer bottle, it seems to fill really fast, then the level sinks very slowly. I'm not sure if it's leaking or if it's just hard to fill - like it has to work its way through in stages.

Is my pump leaking, or is it likely to be a blockage in the main rubber tube? It's hard to see where that goes.

Andy, November 2012

Thanks, cdc.

Can I get to it without taking the wheel arch cover off? I can't see where the motor is, I can only see the washer bottle/tank and the rubber pipe emerging from further back, nearer the windscreen.

I noticed the washer bottle leaks quickly if I try over filling it slightly, but then it seems to level off. I'll check it again in the morning, to see if it's gone any lower over night.

Andy, November 2012

where the washer pump inserts into the reservoir is sometimes a filter which can get blocked,it will be quite easy to see if your reservoir is leaking,look under your motor

cdc, November 2012