I have managed to wire the complete alarm system, 3 x PIRs, 1 x Door Contact, Control Box and LCD Key pad, all looks to be working fine, I am trying to wire a Pyronix Delta Bell but the instructions from the manufacture look complex ( I am not an Electrician but I am ok with simple wiring ). I have tried to compare the instructions for the G4 to the Delta Bell but I am confused as to what wires have to go where. The Delta Bell has instructions for Honeywell systems but I could do with a simplified explanation.

Delta Bell connections are

T
T
FAULT
FAULT
ENG HOLD
STB
BELL
+ 12V
- 12V

The second T down is bridged to the top Fault from the manufacture.

My Accenta G4 control panel has

Speaker symbol
Speaker symbol
+ Strobe
- Strobe
T SCB
A SCB
D Bell +
B Bell -
SET

The T and the A SCB are bridged also from the manufacture.

My cables are 6 core.

Thanks Matt

Matt Smith, November 2012

You can pick whatever colours you want.
But T to T is not a good idea.
READ the manuals.
See what does what and then come back with an question, rather than just wanting it handed on a plate.

Alarm, November 2012

I was hoping for a "use a white wire from T on control panel to T SCB on the siren" type answer.

It may seem obvious if you know alarms but it was the idiots guide I was after thanks.

Matt Smith, November 2012

Knowing the panel and sounder.
With the instructions you have.
There is no way I can make it any simpler.

Alarm, November 2012