the red light is flashing and say call engineer. When the power goes off the alarm works ok. not sure if the basttery need replace if so how do I do this
We don't know if it's been set up for engineers reset or not,nor do we know which one of the scan 9000 range op has at this stage.
But if I remember on most:
Spanner not lit = cust reset.
Spanner lit = engin reset.
And as you have already discovered,I'm the biggest spanner of them all :).
e manno, November 2012
Err, the user code will allow this
acorn, November 2012
Well most started with 9.
9100 9200 9500 9800 9x5x
So in a manner of speaking................
Alarm, November 2012
You could try the default engine code but chances are it's been changed, it's an old system now and if it's not on a maintenance contract then you should know it.
Also there's no such thing as a"scantronic 9000 series alarm".
e manno, November 2012
its simple,you turn power off,open the end station and replace the 7 amp battery,but be warned,you will need the engineering code to reset the panel,do you have this?if not then you have a problem
