Rearming Scantronic 9200 series after zone 1 alarm?
is engineering program code 40 the right code to reset rearm of zone 1 on Scantronic 9200 series alarm
Set off by mistake and user code has stopped bell but then reentering user code to reset is not working for some reason
Hi
I have same prob.
I have the engineers manual, but I've tried code 32 a couple of times, but I bet I'm doing something slightly wrong.
Can someone please give me the EXACT key strokes.
Chhers
Mark Hammond, December 2012
Sounds like that little beauty is on engineers reset by default, good old trusty command "32".
Why do you want to faff around with auto rearm, command "40"?.....read the book or get an engineer in.
e manno, December 2012
no doubt acorn,its as you know a very old ,but good panel,
gts, December 2012
I bet the battery is duff & needs replacing
acorn, December 2012
it has been prog engineer reset,you need the engineering code to reset the system
