Whilst driving my 02 transit after having a bit of noise when I pressed the clutch peddle down . It went all together . Pulled over and there was fluid coming from housing . It's in the garage now it's ad new clutch .plate . Dmf. And bearing and slave . Put it all back together bleed it all there's pressure on peddle but it still won't drive away .can put it in gear whilst the van is running without using the clutch and will go in every gear no probs

Dave, January 2013

I brought new 3 peice clutch kit put that on first and we ad some drive but not a lot . So put a new dmf on and now we av no drive

Dave, January 2013

Thank ppl every bit of help helps been bangin our head even the garage have it a brick wall

Dave, January 2013

guessing it is a RWD,had one like this a while ago and there was a bit of debris stuck to the input flange housing where the bearing sits and this interfered with the clutch meaning it was permanantely disengaged meaning no drive,other things to check are a faulty new clutch and I think there was a pinch bolt at bottom of gear lever onto the selector shaft which came loose,my guess is a fault with the clutch

cdc, January 2013

Thank u il try that . It was running fine until then . Would the garage have to take driveshaft out to change clutch

Dave, January 2013

not in gear,faulty gearbox or no connection between gearbox and engine shaft.it could also mean one of the driveshafts hasn't locked in to diff as both wheels have to have load to drive.Again lift both drive wheels and turn one whilst someone tries to stop the other turning.if no resistance between wheels driveshafts might not be in correctly

Steve, January 2013

Hi thanks wat would that be if it doesn't turn engine

Dave, January 2013

Jack one drive wheel off the floor.put it in gear and see if by turning the wheel it tries to turn the engine over

Steve, January 2013