Hi
I recently moved house, and there's ageneric alarm fitted. I've tracked it down as a Risco, the control panel is a GT-480.
The external box leds flash, and the strobe flashes too. I've armed and reset, and the code I have must be a manager code because it lets me into the settings, but I can't find a way to turn the strobe off.
I'd be more than happy to just disconnect the whole thing to be honest - but I can't see how to power it all off.

Steve, January 2013

It is a fault on the PCB which seems to follow an electric storm. It isn't repairable. Put the strobe wire onto PG1 and program it to bell follow

Steve Pratt, September 2015

Sorry, should have been more specific. I have researched, looked up, downloaded the manual, done everything it says, but there are no errors indicated and the stribe light continues to flash. The manual does not say anything about performing a full reset, or any troubleshooting.

Steve, January 2013

Read the how's,wont's and why's on resetting :)

e manno, January 2013

The user manual is here http://www.riscogroup.co.uk/Downloads.aspx?subcatid=17&id=107
Read it and then come back with your question.

Alarm, January 2013