I have an Ion 40 alarm it keeps beeping and flat rf comes up I have changed batts in Censers can some one help me

Sam, January 2013

Now now GTS , you know the customer tells you how much to charge.

Alarm, January 2013

and sam,i decide what my rate of pay is,this site is a help forum,we give advice,we are in glasgow,if alarm guy near you,then ask him,the i-on by scantronic is a very good system,it tells you the problem,we have fitted hundreads of them,good luck ,check the internal battery,but be sure to turn the mains feed to the panel off ,before you remove the cover,and be careful of the two ariels,they are easy to damage,thats the copper loops at end of the pc board

gts, January 2013

try this,make sure the system is in day mode and unset,press the tick,the display will ask you for your access code,key it in, the bottom line of the display will show a message describing the most recent active alert ,if you press the up and down arrows,the system will show you any other alerts,if all clear,press the tick again,the panel should go green then

gts, January 2013

Where are you and what is a good rate of pay?

Alarm, January 2013

Can gts come and fix it good rates of pay

Sam, January 2013

check the internal battery,also have you any remote units, flat R F radio frequency,means low frequency,could also be a panel fault,or something is trying to block the signal

gts, January 2013