washers on front and rear not working,but you can hear the pump motor working

frank, January 2013

Filter in wash bottle, had that before, it was full of slimy gunk. Depending on model, access is had by taking off the front wheel arch liner, so its wheel off, remove liner, then its a fiddly fiddly job to get the pump off IIRC. Very little room to get your hands in, but no special tools required.

Colin, January 2013

make sure jets are clear using a pin or strand of wire to clean them [and also check there not frozen]then if all ok you will need to clean out filter in washer bottle,this is part of grommet where pump fits-need to remove pump for access.

k, January 2013