alarm goes off after setting and departed from property?
cooper menvier 9448+ alarm system having set the alarm and departed from my house the alarm sounds.On re-entering the the control panel is indicating a fault with zone 2 (hallway entrance) All PIRS are working ok. entering our code disables the alarm sounding.
that dont cut the mustard mate,you need to check the voltage at the pir if its ok,then take it out of the system,i.e.programme it not used,if alarm ok,then replace the pir i do not normaly suggest this but of you dont have a meter its all you can do
gts, February 2013
just light on when movement is detected
p mcdermott, February 2013
thats you been told acorn !!!!!!! but if the pir is working,and thats all that is on the zone,must be cable fault,or air currents,or spiders,or,panel,how did you test the pir??
gts, February 2013
There is a PIR located in this area. It is working.
p mcdermott, February 2013
So what is connected to Zone 2 then that is causing the problem?
