Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

INSTALLING AN HEATING ELEMENT?

i have the heating element but howdo i install it in my electric dryer
RICHIE, November 2006
It would be in your interest that if you post on this site i would advise that you state the type and model of the appliance you wish to repair. Also remember that elements are very delicate and do not stand up to well to harsh treatment. If you have not fixed the problem please post on here again or reply to this post! Cheers.

Carlito Corway, November 2006
usually you need to remove the back pannel and the right hand side pannel to get access to the heating elements and the wires. The panel is secured onto the rear panel with around ten philips screws which must be undone and the cover plate removed.

Be careful with the elements as they are usually on card.

The right side panel removes by undoing the screws on the back and bottom.

Hope this helps but not sure of the model you have

Max, November 2006