Power off at wall and pull the plug out. Remove both hoses from inlet valves. Open the panel. Pull all the wiring plugs out of the control box (they only go back in the same place as they are all different sizes) Remove control box (Have a towel ready because some water will come out as it is water cooled) Remove 2 screws at back of water valves & remove the holding clip. Remove one screw holding water chamber down & then pull chamber plus both valves up & out. Remove faulty valve & swap the rubber seal over to the new one. Refit in reverse order. Run machine & check inside the panel for leaks before screwing panel in place. Most important because you will blow the control board if it gets wet.
Lincoln Appliance NZ, March 2013
